« previous next »
Pages: [1] |   Go Down

Author Topic: locker in a C.A.D. axle?  (Read 831 times)

Offline Jeeper Creeper

  • Level 1
  • *
  • Posts: 71
locker in a C.A.D. axle?
« on: 04/20/08 - 01:35PM »
Our wrangler has a D44 CAD axle up front. Have read a couple of places where installing lockers in a CAD axle causes nothing but problems. Can anyone substantiate this? Should we eliminate the CAD section with a solid axle, or would a auburn limited slip work ok?
Logged
A girl,100lb Chocolate lab, a Jeep with 10 inches of lift and all covered in mud........life is FUN!!

Offline YJ_Aaron

  • Level 5
  • *****
  • Posts: 4255
  • Jeep @ Disney
Re: locker in a C.A.D. axle?
« Reply #1 on: 04/21/08 - 12:04AM »
Lockers don't effect the CAD.  YJ's and some XJ's came that way (CAD) from the factory and a lot of people run lockers in them.  However a solid axle does reduce the number of parts that can fail. 
Logged
Is it possible for a jeep to ever truely be finished?<br /><br />Only the dead have seen the end of war---Plato
Pages: [1] |   Go Up
« previous next »